I have a Briot Accura CX which I have been using for half a year now with no issues.
Few days ago I powered it on to do a large batch of jobs and it came up with a message - Battery Voltage Low.
I did not think much of it as it did not affect operation of the machine and I was able to complete all the jobs.
Yesterday I powered on the machine and as it went through the initial checks where it does all the movements on the scanner and the edger I noticed the stylus did not do any movements.
I then went to do a scan and it came up with a message "Tracer not present".
I tried powering off and on a few times to no avail.
So far from researching the internet I found that to fix the Battery Voltage Low issue I must leave the machine powered on for 14 days.
However, is there anything I can do for the stylus issue?
I am in UK and the technician contact I have said he will be available in 3 weeks time to look into repairing this problem.
Is there anything I can do while I wait in case it is a simple fix?
I have not even been able to figure out how to open the top cover of the to have a closer look. I have the key for machine, but the cover does not lift off. Also the Briot Manual does not say how to open the top cover.
Any advice would be appreciated.
Bookmarks