I doubt there's a solution, but if there is one, Optiboard will have it.

We chose a "F_e_o_" frame from "M_r_h_n" for a guy with a noggin the size of a small musk melon, without a care in regards to the temples being adjustable.

At dispense, they stick back like two arms of a rickshaw, and we can't advance the bend, because we run out of "non-F_e_o_" adjustable metal. There's only so far that you can advance the temple.

Normally, you'd just try to cut the thin wire and file and put the temple cover back on, and voila, 140mm becomes 130mm.


Are there any "hacks" that we can employ, before going through the re-select process (which was no pleasure cruise in the first place, and probably why we settled on the frame that he "wanted")?