Hello,
I am trying to connect an old Weco Trace 2 to my remote edging system. Reading online I found out that this machine does not use the standard VCA-OMA protocol, but it uses some old Weco communication.

Our software receives the data correctly from the tracer, but it can't convert it in VCA-OMA for our edgers.

We receive the data from the tracer in this way:

02
DEV:WECO-FormTracer V 04.15
CON:010707072E0C068400000000000000009D3B00009D4B00007CC90000 0603

NMBR:000001 SIZE:0000 DBL:0134 OFFS:0000

RIGHT: STRT:0A62
FDF6EDE5DEDADADBD9D7DADBE2E6E5E9ECEEF0F3F5F5F5F3F1EFEFE9E8E6 E5E2
E0E2E5EBEFF5FB01070D141B21262C32363B3B3C3D3C3936312B251F1810 08FF
F6EDE4DCD3CBC8C4C2C0C2C1C5CACCD3DAE0E5ECF3FAFF040B0F1312120F 0A05
02FEFCF7F5F4F5F7FA00020810151A21262B30353A3F41403F3B342E261C 1208
INF:040060AB423F110000000000AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA 0000
CIRC:1539 BOXX:0543 BOXY:0351

LEFT: STRT:1A6E
02FAF0E8E3DDDAD8D7D6D9DADEE0E4E7EBEDF0F2F5F5F6F5F2EFECEAE8E4 E3E1
E0E3E6EAEFF6FB01090E16191D232A3032373D3B3D3C3A34322E27201A12 09FF
F5EAE2DAD2C9C4C1C1C2C2C2C3C8CED5D9DFE6ECF3F8FE050C1115151512 0F08
03FEFAF7F5F5F6F6FAFE03070E131A20262B3034393A40423F39372F271E 180D
INF:040B6BA9443B110000000000AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA 0000
CIRC:1536 BOXX:0541 BOXY:0350
ERR:0000
CHCK:597A


We have searched on internet for some manual, or contaced weco, but with no success.

Has anyone else ever had this problem? How can I convert this data in OMA?