Originally Posted by
BioMed
Is it the arm or Lens itself? If arm is damaged you're going to need service for correct calibation. If its the lens you can follow what I wrote, of which some technical dexterity is needed. Loosen front two screws on front cover (patient support assy). Pull from bottom and out slightly, then gradually lift out while pulling from top. While holding front cover disconnect ribbon cable and ground wire. There are two small socket hex screws securing it to the arm. Now the trick is not to remove arm or your calibration is no good. Carefully lift off arm about 1" cut wires and wrap in tape. Notice staggered position of wires. Continue wrapping onto new TLH. This keeps wires tight to make it easier to pull through frame. Secure new TLH and reverse the process.
If you have any questions just email me...d.cox@biomed-ics.com
Bookmarks