Hello,
Have a Zeiss Cirrus OCT 400 series unit. Windows XP and machine itself are fine and functional.

Issue i have is OCT will not capture, application asks to point to db, done correctly, gives message that cannot read db and shuts down (application).
Discovered that original installed capture software was v7.x when unit was purchased (used), and some bright boy downgraded the software to v5.x
Tried a blank db, v5.x i think and still did not work.

Appears the db is for v7.x thus likely the failure.

Zeiss cannot help as unit is end of life.

If I upgrade to v6.x then eventually v7.x can the capture function again?, what about all settings for the unit itself, how to keep or get them re-engaged for v7x

Cannot to do a widows rollback or recovery as they were deleted likely to carry out the unwarranted downgrade.

Any guidance is appreciated or directed to someone who can assist.