Hi everyone,
I have a customer who's Lightec Stainless Steel frame has "split" on the sides of the eyewire (picture attached)
I have seen this happen a few times on these types of design, but usually they have been under warranty periods.
This frame however is a few years out of warrant and the customer is happy to pay as long as not too expensive.
I was going to send to our go to frame repair specialist company that can laser weld joints,
but was just curious is there any other "hacks" or "tips" that can be used in this situation?
Just throwing the net out to see any other good alternatives that work.
Many thanks!
Bookmarks