I am hoping you can help me diagnose this problem and figure out if I need to replace a part. So when the edger (LE9000sx) is chucked with a lens and I have a lens traced, I hit start and the chuck will bring the lens down about 2cm above the wheel, but won't actually hit the wheel. The lens is spinning but just doesn't go down far enough. The chucked lens keeps spinning indefinitely.
This happened after there was a clog in the drain and the chamber had water about halfway up (no water leaked outside of the chamber to the internals/electronics).
I've fixed some minor stuff on the machine, so I'd rather do this myself then try to make a service call since they'll probably have to send someone from a different city and end up costing more than what I could just get a refurbished one for.
Any advise is appreciated. Thank you.
Bookmarks