I brought this home to clean it up and replace the washer where you set the height/angle of the lensmeter. While I am working on it, I'd like to fix the alignment of the center of the target (the 3 thick lines and three thin lines). It has never been quite at the center when the prism is set to zero. I just moved the prism wheel to center it before inserting the lenses but I'd like to have it correct. I got it centered, but then I noticed that the location of the target moves a little as the axis wheel is rotated, so it's only centered at one axis position, like the barrel is off axis. I'm only talking about it being off maybe the width of one of the thick lines, so it's not terrible. But I'd like to get ti properly aligned, if possible.
Does anyone know of an adjustment for that?
Bookmarks