The electricity in the building recently tripped and once again I am left with some equipment issues. My main problem is the sgx. I had replaced the timer on board 2 which was determined to be faulty and now when I put the board in with the new one I get a servo power message on the display of the machine. I have also replaced the two 10Amp fuses that seemed to have been bad and still getting the same message. To add to my issues, my acuity machine keeps resetting itself which is turning the pump on and off. I have switched out solenoid with the polisher and changed the EPROM, both of which has not stopped the issue. Please help!!!!!!