Ultra Optics Mini Help

[chepetech]

Hello,
I have an Ultra Optics Mini II. I have a question...when I prime my coating the fluid sputters and splashes and then it shoots in a straight line up. I took all the air out of the filter and it still splish splashes all over the place and after like 20 seconds it shoots straight up. Is this normal?? If I do a real cycle and put in a lens it splashes on the lens instead of putting on a straight stream right on the center of the lens. Is this nomral? or is it my pump?

Thank you,
Jose

[PRECISIONLAB]

Check your coating level. Normally you should have at least 2.5 bottles in system. Perhaps initially there is the correct level for proper pump function then as coating is depleted the pump might over pressurize the smaller amount. Listen for any changes in pump velocity.

Here is a link to Ultra Optics youtube channel https://www.youtube.com/watch?v=tsc3KAUSusc

[MIOPE]

Also you might want to check if it is leveled. If the machine is inclined to one side,that problem happends.