Hello All,
I am new to this forum and have read the solutions that some of you posted in the past. Very helpful. Thanks for sharing.
I have a little problem with my edger and hoping that some of you may be able to guide me if you had encountered this issue in the past.
I had purchased the Senitellelli edger LE9000 from VSI. I am not good at all with edging and working with the edger. It is a little over a year, so the manufacture warranty is no longer available. Lately I had problem with my tracer and I was able to clear it and get it worked again. The edger works fine now, doesn't give me any error. However, it tends to ask for a big blank size when it comes to edging. After all calculation, the edger said the minimum blank size should be 59, I even used the 68 blank size, set Passive Mode just so I can move the place that I block the lens, the edger/feeler still doesn't touch the lens (meaning I need bigger blank size). It doesn't make sense to me. I am not sure how to fix this or I am missing some knowledge here. I have tried many jobs and same problem. Please help me out.
Thanks in advance.
Bookmarks