I have a Santinelli 7070 with NO tracer attached. I am trying to assess the other functions of the edger to verify if everything else works OK. However, when I put in a practice poly lens using a previous tracing stored in the edger it does not seem to work properly. The edger cuts the lens down quite nicely on the roughing wheel but then does not move the lens onwards to the bevelling wheel. I have set it to metal frame and it should do the bevel. Does anyone have any idea is to why a machine would stop at this point? Could it be the previous tracing that we used (since the tracer does not work this was the only way I could think of to check it).
Bookmarks