The F2 fuse has blown five times in the past few weeks, including 3 times in the past 24 hours. Does anyone have experience with this? It always seems to happen right after the roughing cycle.
The F2 fuse has blown five times in the past few weeks, including 3 times in the past 24 hours. Does anyone have experience with this? It always seems to happen right after the roughing cycle.
I'm Andrew Hamm and I approve this message.
You may need a power conditioner on your input, or short of that run a line quality check on your power where it comes into the machine. IF fuses blow its to protect the equipment, you need to figure out "protect it from what".
It could be irregular sine wave, surges or micro-drops, not enough or too many amps. Either way a power conditioner will fix all of those but if you know the specs on the machine, and have a line tester it will tell you where your power is "dirty".
Last edited by sharpstick777; 04-14-2015 at 11:53 AM.
Hi AngeHamm, I know this thread was from years ago but do you remember of you solved this problem. My Briot just started blowing The F1 and F2 fuses. i get through about 10 or so jobs before it blows. Thanks for any help you could give.
Sorry, I don't remember.
I'm Andrew Hamm and I approve this message.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks