I have a weco 440 with an elision tracer system the edger wont go to the beveling cycle it just stays on the rougher wheel and cuts the lens too small anyone have any idea what we should look at to repair this thank you.
I have a weco 440 with an elision tracer system the edger wont go to the beveling cycle it just stays on the rougher wheel and cuts the lens too small anyone have any idea what we should look at to repair this thank you.
Fix the electronics ! The control; unit must be out of order.Dvai said:
I have a weco 440 with an elision tracer system the edger wont go to the beveling cycle it just stays on the rougher wheel and cuts the lens too small anyone have any idea what we should look at to repair this thank you.
]]
Last edited by Refractingoptician.com; 02-24-2007 at 08:40 AM.
I have weco 430 edge and have the following message after i translate it to english.
2700
Time out at exact stop with following error monitoring:
%9200 N50/5 Axe2
Can you help me with this error message please.
I need a wecco 430 edge manual as soon as possible if some one can help me with that too
dvci i had that problem, it was fixed with a new micro switch on the rotating cam from the back of edger with the cover off. hope this helps jim
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks