this happened all of a sudden to my 9000sx PLB-2R
when i trace a nylon frame,, and set it on nylon aut
will grind lens and polish...but stops after
will not groove... error code 603 ( sfb edge end sensor fault)
however the unit does sfb, when i trace a metal or plastic frame the unit comes out an safety bevels it..
so entered settings attempted sfb calib setup.... asked for reference jig,, so used the LMU jig as the only one i assumed for both. lmu and sfb
all it did was the clamped LMU jig moved down very slowly towards grindin wheel till it stopped, i had to stop/cancel it just stopped there for a while
however since then SFB doesnt come out for any frame type grind
the motor i know works as in video,,
https://www.youtube.com/watch?v=NHOi3RNQV0E
if i move it manually while off will return to position on startup and initialize
and i can grind a lens normally,,just doesnt SFB,, altough lens clamp unit does come down as if SFB unit was there, if i press SFB button
edge sensor volt around 445mv
sfb motor unit itself does spin,,altough main arm wont come forward
https://www.youtube.com/watch?v=InDtC0ovt8A
please help me
thanks
Bookmarks