Hi everyone
Anyone out there with experience changing a roughing wheel on their edger? Is it an easy swap or does the nut need a specific torque or any re-calibration procedure needed?
We have a NIDEK LE 9000 S.
Thanks
Gibby
Hi everyone
Anyone out there with experience changing a roughing wheel on their edger? Is it an easy swap or does the nut need a specific torque or any re-calibration procedure needed?
We have a NIDEK LE 9000 S.
Thanks
Gibby
Here's what I've learned: It;s an easy swap. Loosen nut, R&R roughing wheel and run a few test edgings using demo lenses and see if its under or over.
Seems to be it.....
Yep, that's it. Also, re-lube the shaft.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks