ESSILOR / GC KAPPA TRACER L10 how to access partial test ?

[ex]

Hello
For the tracer ESSILOR / GC KAPPA TRACER L10 , the user's manual describe how to run a complete autotest of the tracer or an autotest of a specific function test like testing the transfer movement.
But I need to access the partial test allowing to check the operation of the table transfer as well as of the corresponding cells and encoders. ( Transfer motor to left , Transfer motor to right , Motor pulses number ,Init switch state)
This option is explained in the L07 Technical Manual.
I suppose it is also explained in a L10 Technical Manual which I have not got.

Any help will be appreciated.
Thanks in advance.

Note : Also I got the errors C6.2/1 C6.2/2 C4.10/2 that I cannot fully decrypt .

[dgg0732]

I have the barcode L10 and L07 for tracer ESSILOR KAPPA. I can to send the barcode on the email.

[charan]

I think it's pressed 5 and 9 at the same time.

[ex]

I have the barcode L10 and L07 for tracer ESSILOR KAPPA. I can to send the barcode on the email.

Thanks
I would appreciate if you can send the barcode to my email I sent you by PM.
Cordially

[ex]

I think it's pressed 5 and 9 at the same time.

Thanks for reply
You are right ; this is the way on the L10 to enter the autotest
but they do not include the partial test I need to test a specific function like the transfer table ( to component level ) ( the L07 way )

[davidsgr]

Hello Everybody....!!!!
It is my first time on this forum and i appriciate about the lot of informations..!!! you are very good team.
My friend has Essilor Kappa and has a problem about the power supply(after 1 working hour stop the power)
I have open the power supply and inside has a lot of dust , after cleaning the dust and the blower, the machine works perfect...!!!
I am new on this field and i need to learn to make a service, can someone inform me where can i found the service/technikal manual for essilor kappa and gamma?

Thanks for reading

David

[davidsgr]

None :(
PLEASE HELP...!!!