Horizon III Edger help...

[Johns]

I've asked this question many times before, but since there seems to be so many new folks around here lately, I thought I'd ask again:

I have a Horizon III patternless edger that is complete except for what is needed to calibrate the edger and the tracer. Does anyone have a set for an edger they no longer have/use?

Thanks

[Jacqui]

Can Leo Hadly help??

[Wes]

I used to have 3 horizon III edgers. What kind of tracer is it? Is is a stand alone?

[Johns]

I used to have 3 horizon III edgers. What kind of tracer is it? Is is a stand alone?

I'm pretty sure it's a Saturn.

[Johns]

Can Leo Hadly help??

I've talked w/Leo about it a few times, and he didn't have any.

[Wes]

Me either. I havent seen or heard of the saturn. Ive always had the 4t tracer. The edger itself is easy enough to calibrate. Just trace the 58mm circle that comes with it to calibrate the probes and pull that trace as a pattern and cut it. when you get it to 58 mm youre good. It may also have a built in calibration pattern, often optronics uses 002 as the default cal pattern. Depends on the year it was put out i think. Try calling optronics support about tracer?

[Johns]

Me either. I havent seen or heard of the saturn. Ive always had the 4t tracer. The edger itself is easy enough to calibrate. Just trace the 58mm circle that comes with it to calibrate the probes and pull that trace as a pattern and cut it. when you get it to 58 mm youre good. It may also have a built in calibration pattern, often optronics uses 002 as the default cal pattern. Depends on the year it was put out i think. Try calling optronics support about tracer?

I don't even have the disc.

I have a 4T as well, but this will be used at a different site, so I can't tie it in.

[Wes]

pm me your address. I have a bag of calibration discs.

[Speed]

To run the axis calibration, you need some pattern blanks with a line along the 180. This should be done each day.

[Refractingoptician.com]

I don't even have the disc.

I have a 4T as well, but this will be used at a different site, so I can't tie it in.

Try Innovative Optical Systems in Sakatchewan, Canada. Speak with Cory . They made patternless retrofits for the Horizon II . They may be able to help you on the Horizon III

http://www.innovativeoptical.com/contact.html

[Johns]

Thanks!

[loratz]

I think I have the calibration tools.I still have my old saturn.

[Johns]

I think I have the calibration tools.I still have my old saturn.

Are you interested in parting with them?

[loratz]

yep

[Wes]

Woo hoo! Does this mean I don't need to mail you a disc?

[HarryChiling]

Woo hoo! Does this mean I don't need to mail you a disc?

I think he still needs a picture though.

[Johns]

Woo hoo! Does this mean I don't need to mail you a disc?

I'm hoping that's what it means! PMs have been sent...

THanks!