Does anyone have a copy of the Reichert Lenschek manual they could email to me? Alternately, If you can post the steps to calibrate it, I would be very thankful. I acquired a unit that was used, and is reading 8-15 degrees off.
Thanks
Does anyone have a copy of the Reichert Lenschek manual they could email to me? Alternately, If you can post the steps to calibrate it, I would be very thankful. I acquired a unit that was used, and is reading 8-15 degrees off.
Thanks
*sound of crickets chirping*
There are some screws on the plate where the eyewear rests...you can tilt to the left or to the right and it will put it into aligment. That machine is awesome and accurate. Do you have a spare printer for it you can sell?
CNG
Hello Tomm, which model do you have? #12621?:idea: I guess I have a copy but I have to look around. If you are interested I could scan it and send it to you.
Please check those links:
http://kendall-optometry-ministry.co...0Lensmeter.pdf
http://kendall-optometry-ministry.co...Eyeglasses.pdf
Best regards,
Fabian.
Duplicated post - Removed
Last edited by Fabian Corio; 09-05-2010 at 02:38 PM. Reason: Duplicated post - removed
I don't have a printer sadly, sorry. Thanks for the tip on the screws.
Fabian, If you could scan just the page regarding use of the Setup or calibration features, you'd be my hero. It is the 12621 btw.
I checked the links you posted a while back and it only had instructions for how to use it, not how to calibrate it.
Thanks again!
Hello Tomm, sorry for the delay in replying.
I am trying to attach the manual (982 kb) but the file upload manager has a 488,3 kb limit. If you let me know how to solve this then your copy will be there tomorrow morning .
I once had the problem you mention and found that some debris inside the nosepiece were blocking the optical path so I bought some canned air and gave the nosepiece a blast (please follow the procedure on page 23, I think that 2 or 3 short shots will do.)
Remember, do not touch the screws on the plate! No alignment can be achieved that way!
Best regards,
Fabian.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks