Mapping a Rimless Drill Job on Essilor Kappa CT Tracer

[emloray]

Folks--
Trying to do one of the new vertical drill mounts....


I know how to go to the Silhouette Website to get the coordinates.

Is there a how to on the procedure to map a drilled rimless?

I can begin the process and photograph the demo lens but when I match the coordinates they don't line up. I match the holes visually but they don't match the suggested coordinates.

Is there a "How to" start and end on this Kappa tracer? for mapping a drill mount?

Appreciate hearing from you all.

Frustrated...:hammer:

Emloray

[emloray]

Boy, I can see this went over big......I actually figured it out and it was easier than I thought. ...After running a couple samples now I can do rimless even when my tech is on vacation. I could before because it was mapped once mapped you can do a hundred.

Emloray