Has anyone experienced the following phenomenon?
You process an expensive Poly (or Platic) Polarized Progressive with a -0.25 cylinder and the lens comes out 15 degrees off axis, everytime. When you finally say "uncle" and try laying it out to compensate for the problem, the lens comes out as you blocked it. Now 15 degrees in the other direction. UGH!!
The only pattern I've seen to this is low cylinder power progressives with an oblique axis ina "layered" material.
I'd appreciate any input to either solving this or confirmming that I'm not a moron.
Rex " Can you really call a -0.25 cyl prog off axis?"
Bookmarks