Hello!
I have recently started working in a lab that, for the most part, had been well-maintained. However, our edger, a GC Spartan, has had a door locking issue that won't quit.
The door sensor had been fried. I replaced that and tested the door cell state as well as activated door locking. All was well. Until the next day. It appears that, after the machine is turned of then back on, our Spartan's door locking is turned disabled again. You can turn it back on and it will work all day, until power down / power up. I have exhausted all of my sources of information so far, including an equipment expert that has been in the field for 30+ years. Also, my technical support department was no help. Their suggestion was to leave it on overnight (not allowed).
If anybody has any input I'd be happy to listen.
Thank you in advance for any help you can provide.
Bookmarks