This threads purpose is to share any tips when using the new VSP frame data entry system.
So far I find entering the SKU is worthless. I'm also just entering a letter under frame info and going right to the next screen and entering data from there. Any detailed frame info on the initial page seems to go into the ether and leaves you at the next screen anyway.
Also I notice that it seems to be hit or miss regarding a drilling fee (V2703) showing up on the fees screen. A silhouette TMA Must had it a Colorama did not. Are you finding this also? I know it's a moot point to some degree as everyone that I've dealt with has drilled rimless coverage.
Again please refrain from VSP flames as this 800 lb. gorilla is here to stay imo.
:)
Bookmarks