Pitting is always more noticeable on Cr39 polar, it is probably happening on clear and trans you just aren't noticing it. First thing you need to focus on is water flow. If any of your milling or...
Type: Posts; User: Dantech; Keyword(s):
Pitting is always more noticeable on Cr39 polar, it is probably happening on clear and trans you just aren't noticing it. First thing you need to focus on is water flow. If any of your milling or...
What i meant is, you can take the air and water out of the equation by running 99% isopropyl alcohol instead of water and disconnecting the air jet. However it seems your lamp may be getting stuck...
You should not adjust those knobs without a laser tachometer, adjusting changes the speeds at which the spindles spin during the cycle. ultra optics will rent you a tachometer for more than they cost...
We run v 2.3, with this update you no longer have to use the calculate button unless your making changes, but the biggest benefit is the fact that it leaves a small bump in the center of poly lenses...
We called them nipples, you can increase your fine time to eliminate these. Or the option i would recommend is updating your software to the new version it compensates to eliminate this problem and...
I'm looking for a wax Eclipse blocker.
Email Dan@acuitylabs.com
With the step one when i install new elevator plates i always take a rough fining pad and sand the steal pin a little bit otherwise our blocks don't always seat correctly. Other things to look at 1....
Are suggesting to wash the lenses before deblocking after being edged? After surfacing a lens we do rinse under cold water after deblocking and removing tape.
We do not edge glass, we run all dry cut machines that use non recyclable coolant to polish.
Thanks guys, Georg i am using a closed loop polish system on each polisher with chiller coils in the reservoir i have a couple ideas on incorporating this filter but it may be a little more...
That's one i haven't heard. What do you use to filter it?
Umm?
Lately we have been having issues with a large amount of scratches skyrocketing our breakage percentage. We have tried many cloths and have finally settled on disposables which seem to have the best...
Sounds like the clarity however you can manually align progressives. Biggest problem is that it is incredibly slow and can take an hour to calibrate our own way due to it not calibrating itself...
We have a clarity it seems to be a work in progress still, we dont shut it off EVER due to calibration nightmares. Have not used the other brands but with accurate techs a lensometer and a 3b will...
I do all of the maintenance and repair on all of our machines we don't use the unity max we use a gerber eclipse for blocking but we do use Optek surfacing equipment. We have 3 contour max generators...
We use 3 of the 7e or hlp edgers two to groove and one for drill mounts along with three 6es. This has significantly reduced our breakage although it is a slightly slower process. The 6es however do...
Innovations should support most oma compliant machines if you are using a serial cable you will sometimes need to change the wiring configuration in some cases a null modem will suffice. Just make...