Search:

Type: Posts; User: hexicola89; Keyword(s):

Search: Search took 0.07 seconds.

  1. Replies
    3
    Views
    524

    Would it work on a V50 generator? If the cycle...

    Would it work on a V50 generator? If the cycle times are less than three minutes, that would be a lot less than toric cyl machines.
  2. Replies
    3
    Views
    524

    Polishing times on satisloh machines?

    Just been looking at the satisloh Toroflex cyl machines. They use soft laps. Are they quicker at polishing than traditional hard laps? Do they use a fining cycle on the same machine, or do they go...
  3. I'm going off the UK College of Optometrists...

    I'm going off the UK College of Optometrists guidance, where it states that unregistered persons must not dispense prescriptions more than two years old, or they may be subject to a level 5 fine. It...
  4. (UK) Is it illegal to repair old glasses?

    If a patient brings in a pair of glasses they bought 4 or 5 years ago and haven't had a sight test since, should we refuse to supply a replacement frame when they damaged the old one?

    It is...
  5. Me too. We never trust the markings on...

    Me too. We never trust the markings on varifocals. Always look for the engraving and block them manually. You could trust old style progs to be right, but not freeform.
  6. Replies
    8
    Views
    957

    Can you get tomato glasses in the USA? Made for...

    Can you get tomato glasses in the USA? Made for babies and special needs kids, little to no metal in them. https://www.tomatoglassesuk.com/
  7. Replies
    5
    Views
    1,258

    Transfer cases.

    In U.K. Specsavers stores, they use soft transfer cases, made of nylon and plastic. You put the frame inside and the docket goes in a sleeve on the outside so you can see the patients details. Then...
  8. Thanks, I will have a look in the morning. I'm...

    Thanks, I will have a look in the morning. I'm guessing this is a "usually closed" solenoid?
  9. Help with plumbing on a Gerber Coburn Acuity Cyl machine.

    We have three Acuity cyl machines, one for smoothing, two for polishing. I want to plumb the smoother into the mains and put a drain in the front trough, that should be easy to figure. We have a...
Results 1 to 9 of 9