Search:

Type: Posts; User: Petter; Keyword(s):

Search: Search took 0.07 seconds.

  1. Poll: Hello. i have two Le 9000 almost the same machine...

    Hello. i have two Le 9000 almost the same machine as 1000 machine . i had to change main card now. i glazed about 46000 lenses on this machine. I friend of mine in Sweden glazed over 200 000 lenses...
  2. Thread: 7070 error

    by Petter
    Replies
    8
    Views
    3,916

    Hello . Just glaze in Passive mode on the edger....

    Hello . Just glaze in Passive mode on the edger. Then you can block all the lens in the middle. Use the mm sentration that appears on the display of the machine when you block.lens..:smile:
  3. Replies
    8
    Views
    5,758

    Hi Fabian I had to change the motherboard. Just...

    Hi Fabian I had to change the motherboard. Just did it now and it works again. Had to make some adjustments ( sizes ). It will probably cost me some dollars :cry: but at least i can do the glazing...
  4. Replies
    8
    Views
    5,758

    Hi Fabian. I did what you suggested and it...

    Hi Fabian. I did what you suggested and it actually worked:smile:When i turned the machine on. Everything looked normal.
    But when i turned it of, it was dead again:frown: The tracer starts as...
  5. Replies
    8
    Views
    5,758

    Ok. it has 1 power supply, so its probably some...

    Ok. it has 1 power supply, so its probably some thing with the mothe board then . its only one mother board.
    Thanks a lot.
    Petter
  6. Replies
    8
    Views
    5,758

    Hi.:smile: i can trace but nothing happens. cant...

    Hi.:smile: i can trace but nothing happens. cant chuck or anything. The buttons does not respons. Its just like the machine is off, except of the light on display ( weak with out any text or numbers...
  7. Replies
    8
    Views
    5,758

    Nidek Le 9000 problem, help :)

    Hi. Can anyone help?
    I have a Nidek Le- 9000 Sx express that will not start. When i use the main switch, i only hear the tracer starting up. The machine will not start.The display on machine is on...
Results 1 to 7 of 7