Printable View
I just recently was given a weco 430. Anyone know why water constantly pumps up through the bottom when the edger is not running. Is this just to keep the chamber clean. I'm running the pump and bucket setup. I am wondering if the selenoid is stuck open.
Do you have the pump plugged into the edger or directly into an outlet? There are 2 plugs on the back of the edger, use the bottom one. If you already are I'm not sure what the problem is. Good luck.
For the time being it's plugged into the wall. I have to get a plug converter for it so it will plug into the back of the edger. The edger didn't come with a pump so I had to make do with a water pump from Lowes. Thanks for the help
Had a cracked boot on the drain of my weco 430. I used a plunger to replace the cracked boot!
That's the problem. It does need to be plugged into the machine to control the water flow. If, after you do that, it still runs continuously or not at all, then the relay needs to be replaced.Quote:
Originally Posted by IGLSPMP
And btw, the power cord uses the same type connector used on computers. Run down to your local computer shop and buy the matching cord, then cut off the end you don't need and replace it with a new outlet from the hardware store.
I have weco 430 edge and have the following message after i translate it to english.
2700
Time out at exact stop with following error monitoring:
%9200 N50/5 Axe2
Can you help me with this error message please.
I need a wecco 430 edge manual as soon as possible if some one can help me with that too ��