If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
We use a Briot XR finishing edger. It is extremely hard after edging to clean the poly groove to get all the white stuff out. We also use a swarf tool. Any tips would be appreciated.
Thanks!
I’m not familiar with that particular edger, but if you can set it to make 1 extra rotation while grooving (water on with last rotation) will help immensely. Any swarf left in the groove can be removed rubbing the lens edge on a piece of carpet.
Comment