• Section Widget

  • Poll Widget

    Are you an Extrovert or an Introvert? (Votes: 66)

    1. Extrovert (Votes: 21)

    2. Introvert (Votes: 45)

  • Categories Widget (Show All)

  • FEA Features on Manufacturing Marvels

    by
    other_bill_fea
    Published on 01-06-2016 11:27 AM
    0 Comments Comments
    FEA Industries has been features on "Manufacturing Marvels", as seen on the Fox Business News channel. Air date was yesterday (1/5/2016), and the segment can be viewed below as well. I think this does well to illustrate the level of machinery that's actually involved in the entire lens surfacing process, and should hopefully help to give people an idea of what really goes on.

    This article was originally published in forum thread: FEA Features on Manufacturing Marvels started by other_bill_fea View original post

  • Recent Forum Posts

    Kwill212

    I'd love to get some takes on the highlighted...

    I'd love to get some takes on the highlighted comment. Obviously increasing the wrap angle will reduce the frame PD as measured in reference to the 0° wrap line. In other words the temporal edges of...

    Kwill212 04-27-2024, 01:42 PM Go to last post
    peyes

    Demo lens?

    Looking for a source for inexpensive plano lenses for demos. Suggestions?

    peyes 04-27-2024, 12:46 PM Go to last post
    peyes

    Demo lens?

    Looking for a source for inexpensive plano lenses for demos. Suggestions?

    peyes 04-27-2024, 12:44 PM Go to last post
    ChrisBowers

    I used to cut this between two plano lenses just...

    I used to cut this between two plano lenses just short of the bevel diameter and apply it to the flattest surface (albeit FT not applicable) also use alcohol as it evaporates nicely.

    Chris

    ChrisBowers 04-27-2024, 08:29 AM Go to last post
    finefocus

    All of this is easier if you first remove the...

    All of this is easier if you first remove the lens from the frame (ala Uilleann) and trim at 45 degrees as 24/7 suggests. You can thumb-squeege the bubbles if the frame isn't in your way,
    Snap the...

    finefocus 04-26-2024, 09:09 PM Go to last post