I'm sure there is a simple fix to my problem so please don't judge. I had a lens that I started to edge and got as far as the roughing cycle when a rush job came in. I stopped the lens and figured I would get back to it later. When I tried running this lens again, the feeler slipped and said the lens was too small. I then hit the frame change icon and tried again and it still would not cut the lens. This also happens when I try to run a patients old lenses into a new frame. There must be some work around to this feeler problem but I just can't figure it out. I always end up having to hand edge the lens which I don't think looks as nice. Thanks for any help you can give to me!