Hello,
The transition lens (high index) with crizal AR coating has shown slight crazing on both lens. It is along the top and bottom edges and can be seen easily when holding it up to a light at an angle.
It has not gotten bad enough to make a difference in my vision, so i was wondering a few things:
- Is this likely to get much worse, to a point where it will impair my vision?
- If so, can AR coating be easily removed?
- Finally, what is likely the cause of this? I do not work near any high heat. I have been in the sun a fair amount, but not for extended periods. I wash my lens with water (slightly warm, definitely not hot) and whatever soap or handsoap is available. This can be hotel soap, bar soap (rubbed onto my fingers and applied to the lens lightly), or hand soap (typical hand soap from a pump that might be moisturizing).
Thanks for any insight or advice on this!
Bookmarks