My boss showed me an old machine back in our garage today and wants me to figure out how to use it. It is apparently called VisionLink and was manufactured by Key Computer Systems Inc. It looks as though it was used to trace frames. There is apparently a 25 pin serial port on the machine itself. And on switch on the whole machine...an on/off button. I did some digging and found disks #1 and 2 of a 3 disk set. Can anyone give me a clue as to what this machine did? And does anyone out there know where I might obtain a copy of the 3rd software installation disk on 3.5. Thank you.
Bookmarks