Hi forum!

We use a Delta edger here that has given us an A08 error. I have seen this before and fixed by lubricating the shaft in the acrylic door holding assembly solenoid which was stuck. But now my brother has tried to fix it and ended up smashing one of the magnets in the sensor.

Unfortunately we are still getting the same A08 error after replacing it with a small piece of neodymium magnet and reversing its polarity a couple times. I'm thinking he might have caused a short on the tiny circuit board with a piece of broken magnet.

The local E is asking for an astronomic amount for this assembly so I came here to plea for your help! I need someone to shed some light on the subject or a good supplier for a new or used part.

Please help me.

Ever so gratefully.

Renfro