password recovery

[Tone2020]

Hi Everyone, Little problem here, Had a customers relative/friend go in my office and take my laptop:angry: , The person didn't make out the door before one of my Optician's nailed him:hammer:, but in the struggle my laptop was dropped and now i can't get by the bios password (cmos) i have tried removing the batteries resetting the jumper pins but nothing:cry: , If anyone can help i would appreciated more than you know Please email me directly so as not to put certain info out:finger: there in cyber space, it's an old laptop that i decided to do my schedules and reports on.

Toshiba Satellite Pro CDX.running win98

Any help or advice would be appreciated Tone2020@aol.com

[optispares]

Hi Everyone, Little problem here, Had a customers relative/friend go in my office and take my laptop:angry: , The person didn't make out the door before one of my Optician's nailed him:hammer:, but in the struggle my laptop was dropped and now i can't get by the bios password (cmos) i have tried removing the batteries resetting the jumper pins but nothing:cry: , If anyone can help i would appreciated more than you know Please email me directly so as not to put certain info out:finger: there in cyber space, it's an old laptop that i decided to do my schedules and reports on.

Toshiba Satellite Pro CDX.running win98

Any help or advice would be appreciated Tone2020@aol.com Toshiba Notebook BIOS password backdoor 2



An other way to bypass the Power On Password of a Toshiba Notebook. This method dose not work on all models Known not to work on Tecra 8000

This is what you need:

1. Your notebook
2. An empty formatted diskette (720 kb or 1,44 mb)
3. A second computer (e.g. a DOS desktop PC)
4. A hex-editor (e.g. Norton DiskEdit or HexWorks)

This is what you have to do:

1. Start the desktop PC and start the hex-editor
2. Put the disk in drive A:
3. Change the first five bytes of sector 2 (boot sector is sector 1) to: 4B 45 59 00 00
4. Save it! Now you have a KEYDISK
5. Remove the disk from drive A:
6. Put the disk in the notebook drive
7. Start the notebook in Boot Mode (push the reset button)
8. Press Enter when asked for Password:
9. You will be asked to Set Password again. Press Y and Enter.
10. You now see the BIOS configuration where you can set a new password.

[Tone2020]

Here's the other thing my laptop doesn't have an A drive just CD drive.

The link that was given was great but i'm not sure of the picture?

Once again Thank you all for your help:cheers:

Thank You,
Tone

[optispares]

Here's the other thing my laptop doesn't have an A drive just CD drive.

The link that was given was great but i'm not sure of the picture?

Once again Thank you all for your help:cheers:

Thank You,
ToneToshiba Notebook BIOS password backdoor 1



How to make the computer lose the password
after you did!


Connect these pins on a DB25 plug to make the dongle:

1-5-10
2-11
3-17
4-12
6-16
7-13
8-14
9-15



http://mitglied.lycos.de/digitaltv/toshiba/parport.jpg

get a spare plug and make the links listed above ie link 1-5-10, 2-11 etc.
then plug it into the port.hope this is clearer.

[Sean]

These may sound a bit off the wall but...:idea:

Some Toshiba laptop systems will bypass the BIOS password if the left shift key is held down during boot.

Try using Toshiba or toshiba as the cmos password. (cmos passwords can be case sensitive)

Many motherboards feature a set of jumpers or dipswitches that will clear the CMOS and wipe all of the custom settings including BIOS passwords. The locations of these jumpers / dipswitches will vary depending on the motherboard manufacturer and ideally you should always refer to the motherboard or computer manufacturers documentation. If the documentation is unavailable, the jumpers/dipswitches can sometimes be found along the edge of the motherboard, next to the CMOS battery, or near the processor. Some manufacturers may label the jumper / dipswitch CLEAR - CLEAR CMOS - CLR - CLRPWD - PASSWD - PASSWORD - PWD. On laptop computers, the dipswitches are usually found under the keyboard or within a compartment at the bottom of the laptop.
Please remember to unplug and remove the battery from your Laptop and use a grounding strip before reaching into your PC and touching the motherboard. If your laptop has this jumper you can reset the jumper switches.To reset the CMOS Settings/Password, move the jumper to the 2-3 position if it is currently 1-2, or 1-2 if it is currently 2-3, then turn on the system, wait a few seconds, then turn the power off.Unplug................ Now, move the jumper back to the original pins. Then reboot.